Hits:Updated:2018-11-21 09:11:22【Print】
Some families installed the radiator, the room was very warm, and after a few years, the house was renovated, but suddenly the room was not warm. Check the heating system and the radiator, and found no abnormalities, no water leakage, no connection, etc. What is the reason why the radiator is not hot? Xiao Bian reminds that the installation position of the radiator is also very important. In the early stage of installation, there will be a surveyor to come to the door, according to the measurement data to issue the installation plan, the program will have a clear recommendation for the installation position of each group of radiators, some locations are the best location for the installation of the radiator, if you change it, the whole The heating system will be affected.
1. The side of the balcony, under the window sill, and in the foyer are the preferred locations for installing radiators. The air convection at these locations is relatively strong, and the heat from the radiator can be distributed throughout the room through the air. If the position of the radiator is arbitrarily changed, the air convection at the installation position is small, the heat dissipation efficiency is greatly reduced, and even the room temperature is uneven, the warm place is dry and dull, and the cold place is cold and windy, which makes people feel uncomfortable.
2. The radiator has strict requirements on the size when it is installed. St. Lawrence radiator installation requirements are 100-150mm from the ground and 50-100mm from the wall. The installation position is lower, and the hot air goes up, which not only makes effective use of the heat source, but also gives people a feeling of comfort and warmth. Close to the wall, but not close to the wall, to ensure that the air convection is normal, and does not take up too much space. Some decoration personnel are not familiar with the knowledge of heating. After the position of the radiator is changed, the heating effect is often not as good as before, and the effect is beautiful.
3. Some districts with central heating, the rooms are refurbished, the radiators are replaced by the position, and even after the assembly is increased, the heat load is increased. Not only the radiators in the home are not as good as the previous heating, but also affect the entire heating system. The heating effect of the whole building or even the entire community is not good.
4. The design of the heating system piping and radiator position is very particular. After installation, if it is disassembled at will, it is easy to have problems such as poor interface and incorrect pipeline inclination, resulting in no heat, leakage and gas. Blocking not only affects the heating effect, but even affects the circulation of the entire unit heating system.
5. Some homes have been over-packaging the radiators during renovations to reduce heat dissipation and should be heated throughout the room. Some families use the radiator in the wall during the decoration, or they have a protective cover on the outside. Once the radiator is leaking or not hot, when repairing, it is necessary to remove the decoration and packaging, causing unnecessary trouble. .
In the early design stage of the heating system, the location and the way of the radiator are strictly regulated. There are many exquisites, including the heating of the whole room, the beautiful appearance of the home, the occupation of the space, etc., St. Lawrence will carry out the system before installation. The design is installed according to the installation plan. Once installed, there is no special situation and it is not recommended to move the radiator position casually.
|
